如何在CNC机器中更改工具|CNC工具更换器如何工作|cnclathing.

数控机床运行时,上有一个传感器工具改变旋转木马告诉机器工具改变在其全部达到收回了公园的位置,如果传感器并不是真的在任何操作的机器,你会得到一个错误的机器,工具改变挺身而出,与Z头部相撞,所以当我们要做一个工具的变化,轴将工具的Z高度变化发生,经历一个主轴方向。它需要定位轴,这样狗与一个槽排列工具改变这剪辑工具改变时,它将从事槽法兰的工具架和主轴的驱动的狗将进入一个小切口,然后工具持有人将保留在工具改变。一旦我们在Z的高度和导向和主轴锁定在其定位位置,然后机器就会呼吁改变的工具,该工具改变时,还有一个限位开关,讲述了电机控制器的工具改变完全工具改变位置,这等待限位开关之前,它将继续循环。

Once the tool changer is in the full change position, we’re going to release the drawbar to let go of the current tool, so when this happens you’ll see the tool change or carousel get pushed down just a little bit and that’s the drawbar completely releasing the tool. There’s a sensor on the drawbar piston to signal when the drawbar has fully released, the machine will not go on until that sensor is made. When that sensor is made then the z-axis will move up to the changing height, once we complete that move, then the signal will be sent to the carousel to rotate to the tool pocket, the next tool is in.

When the spindle comes all the way down again, you’ll see that it pre-loads the carousel just a little bit while the spindle seats completely on the next tool and then once that Z move is complete then the drawbar will release, and then the machine will know that it has the next tool firmly held in the spindle and then it will call for the tool changer to retract and then they will wait to form the tool changer to fully retract and that retract park limits which to be made, so the machine knows that the tool changer is completely out of the way, after that the tool change cycle is complete, the orientation mechanism that locks the spindle and its orientation for the tool change will then release, we can go on to爱游戏ayx娱乐城。